Saab G3 Manuale Utente Scaricare il pdf (Pagina 64)

Service Manual

Third edition, June 1997

5.7.2 Replacing the LCI

Note: In order to avoid ESD-damages (electrostatic discharge), do

not touch the components or the pins in the connector at the back of

the board.

1. Switch the power off before starting this operation.

2. Remove the two screws on the front panel of the board.

Remove the four screws of the Backup Display.

3. Push the knob down to loosen the connector at the back

of the board. See figure 5-4.

4. Pull the both the LCI and the Backup Display out

slightly so that you can remove the connectors on the

flat cables from the Backup Display.

5. Enter the new LCI gently into the slot.

6. Connect connectors to the Backup Display.

7. Push LCI slightly so that it becomes flush with the other

boards.

8. Tighten the screws of LCI and Backup Display. Switch

system on again.

9. Download the database from the Work Station to the

new LCI. See chapter 3.24.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 109 110

Nessun commento

Saab G3 Manuale Utente Pagina 64